Pulox IN-100 Bedienungsanleitung Seite 29

Use:
1. Switch the device on: Press the On/Off button. After 1 second, the
power indicator lights up green and the device starts to atomize.
2. Change mode: The device has two operating modes: level I and level
II. Level I has a high nebulization rate, level II has a low nebulization
rate. The operating mode can be changed as required by briefly
pressing the on/off button.
3. Inhalation: Hold the device in your hand, place the mask on your
face and slowly inhale the medication mist.
Attention:
• If the medication container is not filled with medication, the device
switches off automatically. Before switching off, the indicator light
flickers orange.
• After pressing the on/off button, the device runs through a short
start-up phase (approx. 2 seconds) and then atomizes.
• When the medication runs out, it is recommended to tilt the device
slightly towards the user (the side with the button is closer to the
user) so that the remaining solution can come into contact with the
nebulizer sheet for nebulization.
EN