Singer 7146 Gebrauchsanweisung Seite 20

1
3
c
2
A
4
O
The bobbin thread
Your sewing machine
form a stitch. The upper
the spool and is threaded
the needle. The lower
bobbin. Wind the bobbin before threading
machine.
WINDING THE
Preparation Steps
1 . Raise the presser foot and turn hand wheel
toward you until needle
2. Loosen hand wheel
toward you with the right hand while
hand wheel with the
3. Open slide plate and lift out bobbin.
4. Place spool pin felt on pin.
Winding Steps
• Place thread spool on spool
retaining slit B on top.
end of spool if necessary).
a tube of thread affix
spool pin to ensure even flow of thread.
• Lead thread around
disc C and through
from inside out.
• Place bobbin on spindle
right to engage bobbin
• Hold thread end as
machine. Cut off thread
coils have been wound.
• When required amount
wound (winding will
full), stop the machine
thread.
• Push bobbin to left and
spindle.
• Hold hand wheel and tighten
knob.
uses two threads to
thread comes from
through the eye of
thread comes from the
the
BOBBIN
is in highest position.
knob A by turning
holding
left hand.
pin with thread
(Break paper at the
If you are using
spool pin extension to
bobbin winder tension
small hole in bobbin
and push bobbin to
winder.
shown and start the
end after a few
of thread has been
stop when bobbin is
and cut connecting
remove bobbin from
hand wheel
19
it