Singer 7146 Gebrauchsanweisung Seite 12

00
Oil
o
REMOVING
Raise presser
Raise needle to highest
Open slide plate. Place thumb under right
side of needle plate, lift it up and withdraw
to right.
Replace needle plate under clamping pin A,
push it gently
until it snaps
NEEDLE
1. To insert,
raising shim in the slideway
slide plate as shown.
The raising shim will slide into place under
the needle plate, raising it above the feed.
2. To remove, open the slide plate and pull the
raising shim forward in the slideway.
ATTACHING
Raise presser foot.
Raise needle to highest position by turning
hand wheel toward you. Open slide plate.
c
Slide snap-in
over needle plate until points
positioned directly over holes in needle pla-
te as illustrated. Snap in point B. Then push
point C in toward point B until it snaps into
place. Close slide plate. To remove, open
slide plate then simply lift up front edge of
feed cover.
AND REPLACING
NEEDLE PLATE
foot
position.
to the left and press down
into place.
PLATE RAISING SHIM
(with model 7186)
open the slide plate, place the
and close the
SNAP-IN FEED COVER
(with model 7146)
feed cover away from you
B and C are
it
11