Face Plate - Singer 7146 Gebrauchsanweisung

D
CLEANING YOUR
CAUTION: Before cleaning
connect power line plug
let
With a soft cloth or lint brush,
indicated by arrows,
case area and feed. Also, clean exposed
If necessary a mild solution of soap and water
may be used to remove
other cleaning liquid
used.
Periodically apply a drop
areas indicated after cleaning.
CAUTION: Do not attempt
belt Drive. Refer to your nearest Singer Service
Centre should any adjustments
REMOVING
Loosen screw D (do not remove).
Remove face plate screw E then remove face
plate by drawing it toward you. Replace face
plate by sliding top edge of plate under edge
of arm top cover. Tighten screws E and D.
REPLACING
Place slide plate in slide way with the front
edge close to, but not covering, the retaining
spring F. With a small
end of the spring into each of the side grooves
on the under slide plate. Draw the slide plate
gently toward you to fully engage the spring.
Close slide plate.
MACHINE
your machine, dis-
from your socket out-
clean all points
especially the bobbin
parts.
stubborn stains. No
or powder should be
of oil only to the
to adjust the motor
be required.
FACE PLATE
SLIDE PLATE
screwdriver, lift each
69