Singer 7146 Gebrauchsanweisung Seite 38

Applications with straight
DARNING
With Embroidery Hoop
Needle Position:
Stitch Width:
Stitch Length: O
Needle Plate Raising Shim (with model 71 86)
Snap-in Feed Cover (with model 7146)
No Presser Foot or Presser
Presser Bar: Lowered
Insert needle plate raising shim as instruct-
ed on page 11 (Snap-in
7146 Model).
Trim ragged edges from area to be darned
and centre worn section
designed for machine
Position hoop under
presser bar to engage
thread loosely with
wheel over and draw
through fabric. Hold
lower needle into fabric.
to secure.
Snip off thread ends close
Outline area to be darned
stitches for reinforcement.
Stitch across opening,
needle at a slight angle
upper right. Keep lines of stitching
spaced and even in length. When opening is
filled, cover area with
stitching.
This method of controlling
with an embroidery hoop
embroidering or monogramming.
stitching
Foot Shank
Feed Cover with
in embroidery hoop
use.
the needle and lower
tension. Hold needle
left hand, turn hand
bobbin thread up
both thread ends and
Take a few stitches
to fabric.
with straight
moving hoop under
from lower left to
closely
crosswise lines of
fabric movement
may be used to do