Singer 7146 Gebrauchsanweisung Seite 34

1
2
3
0
0 54
34
o
u
u
II
t
19
6
15
12
4
3/8")
3
Sewing a seam
Needle Position:
Stitch Width:
Stitch Length: To suit fabråc
General Purpose Needle Plate
General Purpose Foot
Raise presser foot. Pull thread back under
1.
presser foot leaving at least 10 cm (4
inches) of thread.
Position needle approximately
2.
inch) from fabric edge. Then lower presser
foot and backstitch
the fabric for reinforcement
reverse direction. For additional
on reverse stitching
Stitch forward to end of seam and stop ma-
chine before the end of stitching
not sew beyond edge of fabric).
Raise needle by turning hand wheel toward
3.
you. Press reverse stitch push button and
back stitch 1 cm (1/2
end of stitching.
Raise needle by turning hand wheel toward
4.
you. Raise foot and remove fabric by
drawing it to the back and to the left. Cut
threads on thread cutter
bar.
KEEPING THE SEAM STRAIGHT
To keep the seam straight, use one of the
numbered guidelines on the needle plate. The
dimensions they represent are shown in the il-
lustration.
CAUTION: Because of the up and down move-
ment of the needle, you must work carefully and
watch the sewing area when operating
chine.
1 cm (1/2
almost to the edge of
by stitching in
information
refer to page 31.
line. (Do
inch) to reinforce
at rear of presser
the ma-
33