Operating The Treadle - Singer 7146 Gebrauchsanweisung

e
10
c
Attaching
Loosen
cover
Disconnect
Loosen
raise motor at pulley E and slip motor belt F
off pulley. Remove motor belt from machine,
then tighten
Slip treadle belt around top of hand wheel
and into hand wheel
Replace cover B and tighten screw A.
B A
Do not replace adaptor plug C.
Engaging and disengaging
Disengage belt when not in use.
To engage belt, turn hand wheel toward you
while guiding belt onto large wheel in cabinet
or stand.
To disengage belt, operate treadle slowly and
shift belt off to the right.
Hold hand
by turning it toward you. Place both feet on
treadle. Turn hand wheel toward you and allow
feet to move freely to follow motion of treadle.
The faster
machine
you are able to regulate speed and are able to
start and keep hand wheel turning
Then
tice treadle
presser foot.
OPERATING MACHINE
FOOT TREADLE
(model 7186 only)
Treadle Belt to Machine
and remove screw
B.
motor plug adaptor C.
motor bracket screw
bracket screw
groove.
drive belt
OPERATING THE TREADLE
whell and loosen
you move your feet, the faster the
will sew. Practice
tighten hand wheel
motion with fabric
WITH
A and remove
D one full turn,
D.
hand wheel knob
this motion until
toward you.
knob and prac-
under the
17