Operating - Singer 7146 Gebrauchsanweisung

0
c

OPERATING

THE
With Electric Motor and Speed Controller
Connecting machine
Before plugging in your
the electrical information
machine A, below the
with the range marked
meter.
Connect plug B to machine
your socket outlet.
To turn the machine
off (E), press switch as shown.
To run the machine
press the speed controller
The harder you press,
chine will sew.
Model 7146 only
To run the machine
press the speed controller F with your foot.
The speed controller
which provides constant
constant penetration
fabrics of varying thickness.
press, the faster the machine will sew.
CAUTION: Disconnect the power
outlet when changing needles, feet or needle plates or when
leaving the machine unattended.
ty of starting the machine by accidentally
controller.
IMPORTANT
Machines for Great Britain
countries having similar wiring standards
are shipped from the factory without a plug
for connection to the mains.
The wires in this mains lead are coloured
accordance with the following code:
Blue - Neutral (N)
As the colours of the
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured
connected to the terminal
with the letter N or coloured
The wire which is coloured
connected to the terminal
with the letter L or coloured
tf a 13 Amp. (BS 1363)
Amp. fuse must be fitted, or if any other
type of plug is used a 5 Amp. fuse must be
fitted either in the plug or adaptor or at the
distribution board.
MACHINE
machine, be sure
on the side of the
hand wheel agrees
on your electrical
and plug C to
and light on (D) or
and control speed,
F with your foot.
the faster the ma-
and control speed,
has electronic circuitry
speed and
when sewing on
The harder you
line plug from the socket
This eliminates the possibili-
pressing the speed
and some other
in
Brown - Live (L)
wires in the mains
blue must be
which is marked
black.
brown must be
which is marked
red.
plug is used a 3
15