Singer 7146 Gebrauchsanweisung Seite 72

2
Raise needle, open slide plate, remove needle
plate and lift out bobbin.
Turn bobbin
will go.
Lift out
Insert bobbin
tion, so that
sition plate C. Turn holder all the way forward
to lock
Replace needle plate and close slide plate.
c
CAUTION: Before changing light bulb make sure
you have disconnected
socket
CAUTION:
watt maximum
1. Removing
With thumb of right hand push in and down on
tab of light lens and lower the light bracket.
Do not attempt to unscrew the bulb.
Press
time
lock the bulb pin and guide out of socket.
Replacing
2.
Press
entering
Turn
in position.
Push
position.
REMOVING BOBBIN
case holder A to back
bobbin case B.
REPLACING BOBBIN
case with a back
front of the case
bobbin case.
CHANGING THE LIGHT
power
outlet.
This machine is designed
bayonet base bulb only.
Bulb
it up into the socket
turn bulb over in direction
Bulb
new bulb into socket,
slots of socket.
it over in direction shown
entire assembly up until
CASE
as far as it
CASE
and forth mo-
is under the po-
BULB
line plug from
to use a 15
and at the same
shown to un-
with bulb pins
to lock bulb
it snaps in
71