Operating The Device Safely - Dometic Power Service Plus25 Motage- Und Bedienungsanleitung

Installing the device safely
DANGER! Explosion hazard
Never mount the device in areas where there is a risk of gas or dust explosion.
CAUTION! Risk of injury
Ensure that the device and the battery is standing firmly. The device and the battery must be set up and
fastened in such a way that it cannot tip over or fall down.
When positioning the device, ensure that all cables are suitably secured to avoid any form of trip
hazard.
NOTICE! Damage hazard
Do not place the battery charger near heat sources (heaters, direct sunlight, gas ovens, etc.).
Set up the device in a dry location where it is protected against splashing water.
Safety when connecting the device electrically
DANGER! Electrocution hazard
For installation on boats: If electrical devices are incorrectly installed on boats, corrosion damage
might occur. Have the device installed by a specialist (marine electrician).
If you are working on electrical systems, ensure that there is somebody close at hand who can help you
in emergencies.
WARNING! Electrocution hazard
Observe the recommended cable cross-sections.
Lay the cables so that they cannot be damaged by the doors or the hood. Crushed cables can lead to
serious injury.
NOTICE! Damage hazard
Use ductwork or cable ducts if it is necessary to lay cables through metal panels or other panels with
sharp edges.
Do not lay the 230 V mains cable and the 12 V cable in the same duct.
Do not lay the cable so that it is loose or heavily kinked.
Fasten the cables securely.
Do not pull on the cables.

Operating the device safely

DANGER! Electrocution hazard
Do not touch exposed cables with your bare hands. This applies especially when operating the device
from the AC mains.
To be able to disconnect the device quickly from the AC power supply, the socket must be close to the
device and be easily accessible.
WARNING! Electrocution hazard
Only use the device in closed, well-ventilated rooms.
EN
5