Scheppach ke 70m Originalbetriebsanleitung Seite 26

Check the general condition of the machine. Check
for loose screws, misalignment or jamming of moving
parts, part breakages and other conditions that could
impair safe operation.
Remove all foreign objects and other materials that
have collected on the saw blade and on the unit.
Clean the machine after every use. Then use a
high-quality, low-viscosity machine oil to lubricate
all moving parts.
m Never use a high-pressure cleaner to clean
your machine. Water can penetrate sealed areas
of the machine and the transmission housing
and cause damage to spindles, gear wheels,
bearings or the engine. The use of high-pressure
cleaners shortens the service life and reduces
the ease of maintenance.
Experienced craftsmen can carry out small repairs
on the machine themselves.
• Check the saw blade at regular intervals. Use only
saw blades that are well sharpened, free of cracks
and not deformed. Only use tools that comply with
the European standard DIN EN 847-1.
16. Changing the saw blade of the roller-bench firewood saw
Attention! Pull out the mains plug!
Wait until stationary and allow to cool down!
The saw blade can only be changed when the table is folded up and is carried out in the following steps:
The protective basket must always be closed.
Fig. 1
26 | GB
• Replace worn swivel frame bearings immediately.
• Check all safety devices after all maintenance or
cleaning work.
• Check that no tools or miscellaneous parts are
on or in the machine before putting it back into
operation.
• Remove any sawdust accumulations that may
arise at the discharge.
Service information
With this product, it is necessary to note that the
following parts are subject to natural or usage-relat-
ed wear, or that the following parts are required as
consumables.
Wearing parts*: Saw blade, table insert, saw blade
guard insert
* may not be included in the scope of delivery!
1 Unlock table stop (E).(Fig. 1)
www.scheppach.com