Scheppach ke 70m Originalbetriebsanleitung Seite 22

Noise data
Measurement of the noise levels was carried out in
accordance with EN ISO 3744:2010.
Sound power level in dB
Idle L / Machining L
WA WA
Sound pressure level at
workstation in dB
Idle LqAeq / Machining LqAeq
The stipulated values are emission values and so do
not necessarily represent safe work station values.
Although there is a correlation between emission
levels and exposure levels, it is not possible to reli-
ably determine whether additional precautionary
measures will be required or not based on this.
8. Assembly
The machine is delivered to you fully assembled.
Only remove the hexagonal screw (A) marked with the red label, which is used as a transport lock. Screw into the
threaded hole (B) for storage.
9. Setup and calibration
• Make sure that the machine is stable on solid ground during assembly.
• The workplace must be well lit.
• The area around the machine must be free of trip hazards.
C
10. Transporting the machine
A
B
22 | GB
ke 70m ke d700
93 / 99 102 / 104
86 / 91 80 / 82
To adjust, pull out the adjustment handle (C) and twist it
for a secure hold (secured by the screw head in the adjust-
ment handle).
For transport, secure the table in a horizontal posi-
tion with the hexagon head screw (A) marked in red.
Only transport the machine using a pallet truck or the
optionally available transport device (article number
10011300).
www.scheppach.com
Factors that influence the exposure level present at
any given time in the work area include the nature
of the working area, other noise sources, e.g. the
number of machines and neighbouring work pro-
cesses. The permissible working values may vary
from country to country. However, the information
should enable the operator to evaluate the hazards
and risks.
7. Scope of delivery
• Roll table circular saw
• Open-end spanner
• Operating instructions