Parkside Performance PHDP 180 C2 Originalbetriebsanleitung Seite 41

Problem
No pressure in device
Water system leaky
Strong pressure fluctuations
Disposal/
environmental
protection
The device, accessories and packaging
should be properly recycled.
Waste electrical and electronic
equipment (WEEE) must not be
disposed of with domestic waste.
The symbol of the crossed-out wheeled bin
means that this product must not be dis-
posed of as unsorted municipal waste at
the end of its useful life.
Possible cause
Air locks in the pressure
washer
Pressure loss in line
Connections not correctly in-
stalled
Water connection (28) leaky Turn off the device and dis-
3-in-1 nozzle (23) is dirty
3-in-1 nozzle (23) clogged
Directive 2012/19/EU on waste
electrical and electronic equip-
ment:
Consumers are legally obliged to recycle
electrical and electronic equipment in
an environmentally sound manner at the
end of its life. In this way, environmentally
friendly and resource-saving recycling is
ensured.
Depending on the implementation in na-
tional law, you may have the following op-
tions:
• Return to a shop,
• Hand over to an official collection
point,
• Return to the manufacturer/distributor.
GB
Error correction
Bleeding, p. 38
Check the water supply
Turn off the device and dis-
connect it from the mains. Re-
connect the device to the wa-
ter supply (see Establishing a
water supply, p. 35)
connect it from the mains.
Change the quick connect-
or for the garden hose ()
including sealing ring (see
Spare parts and accessor-
ies, p. 44)
Rinse the 3-in-1 nozzle (23)
with water. If required, clean
the nozzle bore hole with
a needle (see Cleaning,
p. 39).
Remove the 3-in-1 nozzle
(23) and ensure that the wa-
ter can discharge from the
trigger gun (1) unimpeded.
MT
41