Parkside Performance PHDP 180 C2 Originalbetriebsanleitung Seite 40

GB MT
anything, check whether the batteries
are inserted correctly.
5. Insert the cover of the battery compart-
ment.
6. Fasten the cover of the battery com-
partment using the screw.
Maintenance
The device is maintenance free.
Storage
Notes
Always store the device and accessories:
• clean
• dry
• protected against dust
• protected against frost
• out of the reach of children
Preparing the device for storage
NOTICE! The pressure washer and ac-
cessories will be destroyed by frost if they
are not completely emptied of water.
1. Completely empty the water from the
device.
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not work
Device does not convey wa-
ter
40
• Disconnect the device from the wa-
• Turn on the pressure washer with the
• Press the switch lever (17) on the
• Turn off the device.
2. Completely empty the water from the
3. Store all attachments upright in the
4. Roll the high-pressure hose around the
5. Store the mains connection cable in the
Possible cause
On/Off switch (32) turned
off
No mains power supply
Incorrect voltage supply
Air locks in the pressure
washer
ter supply.
On/Off switch (32) for a maximum
of 1 minute.
trigger gun (1) until there is no more
water coming out of the trigger gun
(1) or the attachments.
accessories.
holders with the connection facing
downwards.
hose reel (5).
holder (11) provided.
Error correction
Check the position of the
On/Off switch
Check the socket, mains con-
nection cable, plug and fuse
and have them repaired by a
qualified electrician if neces-
sary.
Check whether the electrical
system matches the informa-
tion on the type plate
Turn the device on and press
the switch lever (17).
Bleeding, p. 38