Parkside Performance PHDP 180 C2 Originalbetriebsanleitung Seite 35

The LC display shows the selected pres-
sure. If the LC display is not display-
ing anything, check the direction of the
batteries.
5. Insert the cover of the battery compart-
ment.
6. Fasten the cover of the battery com-
partment using the screw.
Setting up the device
1. Place the device horizontally on a level
surface.
2. Make sure that the high-pressure hose
(8) passes through the guide for the
high-pressure hose (9).
3. Insert the high-pressure hose (8) into
the high-pressure connection on the
trigger gun (1).
Establishing a water supply
You have two options to supply the device
with water:
• Household water connection
• Suctioning standing, clean water, e.g.
rain barrel
Household water connection
Requirements
• Supply hose: Garden hose with fit-
ted quick connector with garden hose
adaptor (34); ⌀ 13 mm (½"); length
between 5 m and 30 m
• Minimum pump capacity: 540 l/h
(9 l/min)
• System separator
A system separator (check valve)
prevents the backflow of water and
cleaning agent into the drinking water
pipeline.
• According to current regulations, a
pressure washer must never be con-
nected to the drinking water network
without a system separator. A suit-
able system separator must be used
in accordance with EN 12729 Type
BA.
• Water that has flowed through a
system separator is classified as non-
potable.
• System separators are available
from specialist dealers.
Procedure
1. Insert the filter insert (30) in the water
connection (28).
2. Fit the coupling (29) on the water con-
nection (28).
3. Attach the quick connector with
garden hose adaptor (34) to the sup-
ply hose.
• Remove the grooved clamping nut.
• Push the clamping nut over the end
of the hose.
• Insert the end of the hose into the
thread of the quick connector with
garden hose adaptor.
• Fix the quick connector with garden
hose adaptor with the clamping nut.
• Check whether the quick connector
with garden hose adaptor is fitted
securely to the hose.
4. Connect the supply hose to the water
supply.
5. Bleed the supply hose: Open the water
supply until the water flows bubble-free
out of the other end of the supply hose.
Close the water supply.
6. Connect the quick connector with
garden hose adaptor (34) on the sup-
ply hose to the coupling (29).
Suctioning water
Requirements
• NOTICE! Contamination from back-
washed cleaning agent! Do not draw
in any water from natural accumula-
tions.
GB MT
35