Parkside Performance PHDP 180 C2 Originalbetriebsanleitung Seite 36

GB MT
• Suction hose with filter basket (not in-
cluded, Spare parts and accessories,
p. 44)
• standing, clean water, e.g. rain barrel
• Max. suction height: 0.5 m
Procedure
WARNING! Electric shock! The
device itself must not be submerged in the
water collector.
NOTICE! Damage due to dry running! En-
sure there is a sufficient and reliable water
supply.
1. Connect the suction hose with filter
basket to the coupling (29) on the wa-
ter connection (28) of the device.
2. Insert the end with the filter basket into
the water collector.
3. Remove the lance (4) from the trigger
gun (1).
4. Press and hold the switch lever (17).
5. Move the On/Off switch (32) to the
position "I" (ON).
The device begins to suction water and
air can escape.
6. Once the device is free of air, you can
release the switch lever.
7. Fit an attachment.
Select the attachment
3-in-1 nozzle (23)
You can choose from 3 nozzles by rotat-
ing the tip. A symbol on the lance exten-
sion shows the nozzle which is selected.
Spot jet
Flat spray (30°)
Foam nozzle for cleaning agent
36
Turbo dirt blaster (22)
The rotating water jet is suitable for
working with low water consump-
tion.
Surface cleaner (24)
Notes
• Only use the surface cleaner on solid
surfaces.
• Never raise the surface cleaner while
the pressure jet is active.
Properties
• Splash-free high-pressure cleaning of
floor and wall surfaces
• High degree of cleaning through rotat-
ing nozzles
• Pressure regulator
Control elements
• Pressure regulator (25)
⭮ Higher pressure, spray arms rotate
faster
⭯ Lower pressure, spray arms rotate
slower
Fitting and removing
attachments
Fitting the nozzle
1. Fit the lance (4) on the trigger gun (1)
(Bayonet locking device: plug and
turn).
2. Pull and hold the quick connector ring
(21) on the lance (4).
3. Fit the attachment on the lance (4).
4. Release the quick connector ring (21).
The attachment clicks into place.
Removing the nozzle
1. Pull and hold the quick connector ring
(21) on the lance (4).
2. Pull the attachment off the lance (4).
3. Release the quick connector ring (21).
4. Remove the lance (4) from the trigger
gun (1) (Bayonet locking device: push,
turn and pull).