Parkside Performance PBSPA 12 A1 Originalbetriebsanleitung Seite 23

1. Remove the battery (5) from the appli-
ance if necessary.
2. Insert the battery (5) in the charging
compartment of the battery charger
(16).
3. Plug the battery charger (16) into a
mains outlet.
4. Unplug the battery charger (16) from
the mains.
5. Pull the battery (5) out of the battery
charger (16).
Overview of the LED indicators on
the charger (16):
Green LED illuminated while the
rechargeable battery is not inserted:
Charger is ready
Green LED lights up: Battery is charged
Red LED lights up: Battery charging
Red LED flashes: Error
Choice of gear
Slide the gear selector (3) to 1 or 2,
corresponding to a low or high torque
selection.
1st gear .............................0-400 min
2nd gear .........................0-1400 min
A gear change may only be per-
formed in standstill mode!
Set the direction of
rotation
You can select the direction of rotation with
the direction switch (clockwise and anti-
clockwise direction) and secure the device
against accidental start up.
The arrow on the direction switch indicates
the working direction.
1. Wait for the device to shut-down.
2. Clockwise direction: Press
direction switch (4) to the right.
3. Anticlockwise direction: Press
direction switch (4) to the left.
4. Switch lock: Bring direction switch (4)
to neutral position.
The direction changed may only be
performed in standstill mode.
Torque setting
You can preset the maximum torque by
rotating the torque adjustment ring (2).
20+1 torque levels are provided.
1. Turn the adjusting ring (2) to select the
desired torque:
Step 1 -->
Step
-->
Screws:
Drilling:
2. Start with a lower torque step and in-
crease according to requirement.
Torque adjustment should only be
performed in standstill mode.
-1
-1
Reaching the preset torque limit pro-
duces a noticeable rasping sound.
This sound is caused by the slip
clutch.
Tool change
The automatic spindle lock enables the tool
to be changed even when the motor is at a
standstill.
1. Rotate the keyless chuck (1) towards
until the drill chuck aperture
RELEASE
(11) is large enough to accommodate
the tool.
GB
lowest torque,
highest torque.
Steps 1 - 20
Step
IE
23