TROUBLE
Problem
/
Model
doesn't
move
Loss
of Control
SHOOTING
Cause/
Transmitter or chassis power switch is
not ON
Polarity or battery type is wrong.
Batteries
have
run
low.
Pairing is cancelled.
LED on chassis is flashing
LED on chassis takes a long time to
light up
FWD and REV control are opposite.
Left and right control are opposite.
Batteries
have
run
low.
Antenna is not straightened up
Other devices using 2.4GHz are being
used close by.
Main road or large steel pylon is nearby.
Front
Wheels
vibrate
side
/
Correction
Switch power on as per Instruction
Manual
Check polarity and type as per Instruction
Manual
Change batteries as per Instruction
Manual
Complete the pairing process again as per
instruction
Switch transmitter and chassis power OFF.
After 5 seconds, switch power back ON.
Other 2.4GHz
area may cause a delay. This is not a fault
Cancel reverse control function as per P39
Cancel
per P38.
Change batteries as per Instruction
Manual
Straighten up antenna on transmitter and
chassis.
Operate model in a different area, or
stop using the other device.
Run
model
*fiWPfiü-kå0
Due to high performance
to side
vibration may occur. This is not a fault
55
! ?
/
P23.
P 17
P17.
manual
P 18 - 21
devices
or transmitters
the
reverse
control
function
P 17.
in different
area.
digital servo some
in the
as