Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Startup / Operation
6.4.5.1 Detergent dosing
Pre-dosing
Description
Prerequisite:
External enable ("EN-VD") configured
Enable:
EN-VD = 1 and simultaneously LF < 0.5mS/cm (tank empty)
Special features:
n
n
n
Process:
n
n
End:
n
Note: If post-dosing is active (EN-ND = 1) and the conductivity is >
80% of the setpoint value, pre-dosing ends.
Behaviour in the event
n
of an alarm
n
Behaviour in
n
parameter setting/
n
Configuration
Comment: "[xx]" indicates the corresponding display, see
on page 40
Post-dosing
Description
Dishwasher type
Metering modes
Time-controlled or conductivity controlled
Enable
n
n
Dosing process
For "time-controlled":
n
n
Comment: EN-ND stops dosing and resets the dosing time
For "Conductivity controlled":
n
Behaviour in the event
n
of an alarm
n
n
Behaviour in
n
parameter setting/
n
Configuration
Comment: "[xx]" indicates the corresponding display, see
on page 40
MAN050481 Ver. 04-06.2024
Process once only per washing cycle
Changes EN-VD to 0 Ü VD stops
New enable possible, either:
–
By metering unit = OFF
or
–
- No EN active - Conductivity < 50% of nominal value for > 5
minutes
Delay time expires
Dosing time expires
Pre-dosing time expired
Dosing interrupted
Times continue to run
Times reset
New pre-dosing possible
For external enable: Status EN-ND = 1
For internal enable: Metering unit = ON
Expiry of dosing time
Then stop
Depending on concentration (with self-learning function)
Dosing interrupted
Times reset
New process after new enable
Times reset
New re-dosing possible
Ä
Ä
48
Setting in
Setup [114]
Parameters
[42] or [52]
'Program structure'
Setting in
Setup [111]
Setup [112]
Setup [114]
Parameter [53]
Parameters
[43], [44], [45]
'Program structure'
Werbung
