Scheppach ETHT500 Originalbetriebsanleitung Seite 28

• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards).
- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Product works with
interruptions.
Cutter bar becomes hot.
Poor cutting results.
28 | GB
Possible cause
On/off switch defective
Motor defective.
Internal loose contact.
On/off switch defective
Cutter bar blunt.
Cutter bar has nicks.
Too much friction due to lack
of lubrication.
Cutter bar blunt.
Too much friction due to lack
of lubrication.
Dirty cutter bar.
Poor cutting technique.
www.scheppach.com
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
Remedy
Repair by an authorised service centre.
Repair by an authorised service centre.
Please contact our service department.
Check cutter bar, sharpen or contact our service
department.
Oil the cutter bar.
Check cutter bar, sharpen or contact our service
department.
Oil the cutter bar.
Clean the cutter bar.
Observe the working instructions.