Changing Light Fuse, The Optional Fan And The Unit Electronics; Changing The Clock Battery - Sentiotec CK 3 Gebrauchsanweisung

Installation instructions for trained electricians only
8 Changing Light fuse, the optio-
nal fan and the unit electronics
Figure 3
WARNING - Electric shock:
Disconnect all pins of the sauna control from
the mains and secure from unintentional swit-
ching on prior to opening the cover of the
housing.
1. Remove housing cover 5 according to chapter
2.
2. Carefully remove operating unit 1 from base of
housing 6.
3. Fuse for cabin lighting
(miniature fuse 5x20 T2.0 A / 250V) 9 or
fuse for fan
(subminiature fuse TR 5 - T 1.0 A / 250V) 7 or
fuse for unit electronics
(miniature fuse 5x20 T630 mA / 250V) A.
4. Insert strips 2 of operating unit 1 into both
holding fixtures 3 on the sides and carefully push
down on the base of the housing 6 until it locks
in position.
5. Fit the housing cover 5 on the base of the hou-
sing 6, rotate it downwards and push down on
it until you can hear it lock in position.
Check for secure fit of the control .
38
9

Changing the clock battery

Figure 3
WARNING - Electric shock:
Disconnect all pins of the sauna control from
the mains and secure from unintentional swit-
ching on prior to opening the cover of the
housing.
1. Remove housing cover 5 according to chapter 2.
2. Carefully remove operating unit 1 from base of
housing 6.
3. Replace battery (type CR2032) 8 for clock on up-
per board.
4. Insert strips 2 of operating unit 1 into both holding
fixtures 3 on the sides and carefully push down on
the base of the housing 6 until it locks in position.
5. Fit the housing cover on the base of the housing 1
rotate it downwards and push down until you hear it
lock in position.
Check for secure fit of the control .