Operating Modes - Sentiotec CK 3 Gebrauchsanweisung

2

Operating modes

You have two operating modes: sauna and climate
operation.
You can start the operating modes directly via "quick-
start" or once the selected automatic start-time is re-
ached (time-delayed switch-on of stove).
During sauna operation you will have dry heat at your
disposal. The temperature is high, the humidity is low.
The LED displays 4, 5 and C - G will be red when
the sauna is in operation.
During climate operation the temperature in the
sauna cabin will be lower, but the relative humidity will
be significantly higher.
The LED displays 4, 5 and B - G will be green
when the sauna is in operation.
A fan allows cabin ventilation independent of the ope-
rating mode.
A final cabin drying program (see chapter 11) will
start automatically as soon as climate operation has
stopped. It will switch off as soon as drying is comple-
ted.
Operating instructions for the user 9
2 Operating modes - Continued
What can be programmed?
1. Start of heating = LED: START F:
to set the automatic start of heating from 0 - 24
hrs.,
e.g. [18:00] hrs.
2. Heating duration = LED: TIME E:
to set the heating duration,
e. g. [02:30] hours and minutes
3. Temperature = LED: TEMP D:
to set the temperature between
10 - 110 degrees Celsius in sauna operation
and
10 - 80 degrees Celsius in climate operation
e.g. sauna operation [95° Celsius],
4. Fan speed = LED: VENT C:
to set the fan speed from 0% - 100%,
e.g. [50%] percent
5. Relative humidity = LED: CLIMATE B:
to set the relative humidity from 10% - 80%,
e. g. [70%] percent
The settings can be changed during sauna and climate
operation.
Sauna operation stops automatically once the selected
heating duration has lapsed.
In climate operation, a final cabin drying program (DRY)
will run at the end of the heating duration.
43