Automatic Climate Operation - Sentiotec Ck 3 Gebrauchsanweisung

Climate operation
9 Automatic
9.1 Switching on the sauna control
1. Press ON/OFF 1.
The LEDs B - F light up for approx. 5 seconds.
-
- The LED of the previously selected bath, SAUNA
H or CLIMATE A lights up.
The display 6 indicates the current time
-
(e.g.16:30 hours):
16:30
9.2 Setting to climate operation
1. Press Climate button A.
The LED of Climate button A lights up.
The display 6 indicates the current time.
-
9.3 Select the start of heating [00:00 - 23:59
hours]
WARNING - Fire hazard:
Prior to turning the sauna control to auto-
matic operation make sure that no com-
bustible objects have been placed on top
of the stove.
1. Press UP/DOWN buttons 8 until LED START F
lights up:
The display 6 indicates:
OFF
or the value set previously.
2. Press PROG/OK 9:
The display 6 flashes:
-
OFF
- or the value set previously..
3. Use the UP/DOWN buttons 8 to enter the desired
value, e.g. [18:00].
- The display 6 flashes:
18:00
Operating instructions for the user 9
Climate operation
9 Automatic
4. Press PROG/OK 9:
- The display 6 indicates:
18:00
The LED AUTOMATIC 5 lights up.
-
- The automatic start time for heating has been set.
Note - Deactivating the start of heating:
Turn ON/OFF switch 1 off and on again.
The LED AUTOMATIC 5 goes out,
or
press the SAUNA H or CLIMATE A buttons.
The LED AUTOMATIC 5 goes out.
Please also refer to chapter 7.7 for turning off the
automatic start of heating.
9.4 Entering the temperature (10 - 80° C)
1. Press UP/DOWN buttons 8 until the LED TEMP
D lights up:
- The display 6 indicates the current sauna ca-
bin temperature, e.g. [22° C]
22°
or the value set previously.
2. Press PROG/OK 9:
- The display 6 flashes:
50°
or the value set previously.
3. Use the UP/DOWN buttons 8 to enter the desired
value (min. 10° C; max. 80° C)
e. g. [65° C]:
- The display 6 flashes:
65°
4. Press PROG/OK 9:
- The display 6 indicates again the current sauna
cabin temperature, e.g. [22° C]:
22°
- The temperature has been set.
Continued
51