MICRO-EPSILON optoNCDT 1900 Betriebsanleitung Seite 111

Anhang | ASCII-Kommunikation mit Sensor
Beispiele:
a|b
a b
a [b [c]]
PASSWD <Old password>
<New password> <New password>
Welche Unterkommandos gibt es zu dem
Befehl MEASSETTINGS?
Senden Sie den Befehl HELP MEAS-
SETTINGS
an den Sensor
optoNCDT 1900
// Verwende a oder b
// Beide Parameter sind erforderlich
// Nicht feststehende Anzahl an Parametern: a, a b, oder a b c
// Um das Passwort zu ändern, sind alle Parameter erforderlich.
->help meassettings
MEASSETTINGS <subcommand> [<name>]
Handle application-dependent measuring settings. Either use a PRESET prepared by the
manufacturer (PRESETMODE and setting from PRESETLIST), or use a user-defined setting.
Each setup can be stored as user-defined setting.
PRESETMODE: Get current preset mode
PRESETMODE <mode>: Set preset mode, <mode> = STATIC|BALANCED|DYNAMIC
PRESETLIST: List all manufacturer settings
CURRENT: Get name of current setting
READ <name>: Load setting <name> from persistent memory
STORE <name new>: Write user-defined setting into persistent memory
RENAME <name> <name new> [FORCE]: Rename user-defined setting
DELETE <name>: Remove user-defined setting <name> from persistent memory
INITIAL AUTO: Load the last stored setting when the sensor is started
LIST: List the names of all stored user-defined settings
FORCE: Allow overwriting of an existing user-defined setting.
<name> The name of a manufacturer setting or a user-defined setting.
<name new> The name of a user-defined setting. Names must contain at least 2
characters, and can contain a maximum of 31 characters.
The following characters are permitted: a-zA-Z0-9_
The names of presets are not allowed, and names may not begin
with ''AUTO''.
Seite 111