Electrically Adjustable Seating System; Comfort Leg Rests (Optional) - Handicare Hippo Bedienungsanleitung

Operating instructions
3.2.7

Electrically adjustable seating system

The following parts may be adjusted electrically:

seating height

tilting angle
Depending on your particular wheelchair version, one or more of the following parts
may be electrically adjusted (optional):

leg rests

back angle
The electrical adjustment is carried out using the knob on the controller and the
joystick:
1. Select the part you wish to adjust by pressing the corresponding knob on the
controller. The indicator light will go on to indicate that the corresponding part has
been selected, see Figure 19: The following parts may be adjusted:
indicator 1 both leg rests simultaneously
indicator 2 left-hand side leg rest
indicator 3 right-hand side leg rest
indicator 4 back angle
indicator 5 tilting angle
indicator 6 high/low adjustment
2. Select the desired position for the part by pushing the joystick away from you (part
will move downward or forward) or pulling it towards you (part will move upward or
back).
Warning!
When electrically adjusting the seat height, take care not to get
anything trapped between seat and frame.
Keep all persons and their body parts away from the danger zone
3.2.8

Comfort leg rests (optional)

The comfort leg rest
The comfort leg rest has a hinge point at knee height and can be adjusted using the
gas spring.
1. Push handle A forward to unlock the gas spring.
2. Move your leg to the desired position.
3. Release the handle, which will lock the gas spring.
22