Headrest - Handicare Hippo Bedienungsanleitung

Operating instructions
1. Using Allen key number 4, unscrew the adjusting bolt, see Figure 9 .
2. Slide the controller to the desired position.
3. Tighten the adjusting bolt.
Height adjustment
The controller housing may be set in driving position or in lower position. This latter
position is useful when taking place at a table. When in driving position, the controller
housing is locked. The height of the driving position is adjusted as follows:
1. Put the controller in the lower position, see Figure 10 above.
2. Unscrew the M6 bolt, see Figure 10 above.
3. Move the pin to the desired position.
4. Tighten the bolt.
3.2.5

Headrest

Height, depth, and angle adjustment
1. Using Allen key number 5, unscrew the three M6 bolts, see Figuur 11.
2. Turn the head rest to the desired position (desired height, depth, and angle).
3. Tighten the bolts.
20
Figure 10
M6 bolt
Controller release