Storage; Waste Disposal - Elmo Rietschle V Serie Originalbetriebsanleitung

8.11 Storage

The following requirements for the storage location must be observed in order to store the unused pump in a
proper condition over a longer period of time. If the following requirements are not observed, the pump may
be damaged. Storage without oil filling is recommended. The storage location must
• the storage place must be dry and clean
• the storage place must be level
• the storage place must be protected from sudden changes in temperature and humidity
• the storage location must be protected from salt spray, industrial gases, corrosive liquids, rodents and
fungal attack
Restocking
If the pump is to be stored for a longer period of time (more than two months) after use, the following steps
must be observed.
1. Ensure that the pump is free of water or water vapour.
2. To do this, close the intake. Set the vacuum regulating valve to the maximum vacuum.
3. Allow the pump to run for 30 minutes after reaching operating temperature. Only draw in a small
amount of dry ambient air.
4. Immediately after switching off the pump, seal all inlets and outlets with sealing plugs.
5. Silica gel packets must be placed inside the filter housing. Attach a warning sticker so that the
packets can be removed again before commissioning.
NOTICE

8.12 Waste disposal

NOTE
For a description of the safety instructions, see chapter 2.9.
The pump is disposed of in a disassembled state. See chapter 8.10
When disposing of the pump, the relevant local environmental regulations must be observed.
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
If the pump was pumping air with a high moisture content before the shutdown
period, the above steps are also recommended for shorter storage periods.
MAINTENANCE, SERVICING AND DISMANTLING
www.elmorietschle.com © Gardner Denver Schopfheim GmbH
Tel. 071 918 60 60, Mail: v-g@prematic.ch
37
|