Installation And Commissioning; General Requirements - Elmo Rietschle V Serie Originalbetriebsanleitung

6

INSTALLATION AND COMMISSIONING

6.1

General requirements

The installation location of the pump should be dry and protected from splashing water.
We recommend setting up the pump so that maintenance work can be carried out easily. Depending on the
type of variant or accessories fitted, additional clearance may be required for this.
The following points must be observed when installing components and assemblies in order to avoid injuries
and damage to the pump.
• Components from third-party manufacturers may only be installed if they have been approved by the
manufacturer and comply with the directives and laws applicable in the country of use.
• Loose and non-pump parts must be removed from the pump environment after assembly.
• Protruding parts (pipes, cables, etc.) must be properly mounted, routed and marked.
• Contact points of components must be clean and intact.
Installation
Fig. 5
WARNING
A A
10 cm 10 cm
Tab. 3 Minimum distances
NOTE
Fastening to the substrate
The pump can be installed on solid ground without anchoring. When installing on a static sub-
structure, the built-in feet must be screwed in from below and thus fixed.
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
Outside the permitted operating parameters, safe operation of the pump can no
longer be guaranteed see chapter 9.1).
The minimum distance of the pump to all adjacent parts must be considered
according to the following table. Failure to observe the minimum distances may
result in a fire risk due to the high level of heat emitted.
B B
10 cm 10 cm 10 cm 10 cm
INSTALLATION AND COMMISSIONING
C C D D
10 cm 10 cm
www.elmorietschle.com © Gardner Denver Schopfheim GmbH
Tel. 071 918 60 60, Mail: v-g@prematic.ch
E E
10 cm 10 cm
19
|