Dismantling And Decommissioning - Elmo Rietschle V Serie Originalbetriebsanleitung

MAINTENANCE, SERVICING AND DISMANTLING

8.10 Dismantling and Decommissioning

DANGER
DANGER
DANGER
WARNING
NOTICE
CAUTION
NOTE
For a description of the safety instructions, see chapter 2.9.
The following steps must be observed during dismantling and decommissioning:
1. Switch off the pump and release the drive.
2. Switch off the power supply and secure it against being switched on again unintentionally.
3. Disconnect the supply line of the drive.
4. Shut off media lines and divert pressure differences if necessary.
5. Disconnect the media lines from the pump.
6. Clean the pump thoroughly
7. Disassemble the pump in reverse order of assembly or according to separate disassembly
instructions. Loose parts must be secured to prevent them from tipping over or falling down.
8. Protect the pump from further contamination.
36
|
www.elmorietschle.com © Gardner Denver Schopfheim GmbH
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
Danger to life due to unexpected start-up.
Danger to life due to defective, dismantled and manipulated protective devices
Risk of injury from slipping, tripping and falling
Danger from hot components
Incorrectly executed cleaning and the use of incorrect cleaning agents or clea-
ning equipment (e.g. high-pressure cleaners) can cause damage to the pump.
wear suitable personal protective equipment (PPE for short).
Tel. 071 918 60 60, Mail: v-g@prematic.ch