G) Mounting The Propeller - Reely 1542912 Bedienungsanleitung

• If you pull the control stick for the elevator and the fin unit to the right, the fin unit must deflect to the right. This
pushes the landing gear to the left in flight and the model will roll around the longitudinal axis to the right due to the
changed flow situation on the wings.
• You have to slightly pull on the elevator so that the model does not loose any height in this slanted position.
• After completing the test, first turn off the model and then the transmitter; remove the flight battery from the model.

g) Mounting the propeller

• If you look at the model from the rear, the motor turns
the propeller (1) clockwise.
• Place the propeller on the catch (2) so that it propels the
air backwards in the rotation direction described above.
• The propeller tappet is secured on the motor shaft with
a grub screw. The model includes a suitable hex key to
tighten the grub screw.
• A suitable wrench is enclosed to attach the propeller
nut (3).
Figure 13
Figure 14
45