Werbung
Verfügbare Sprachen
Verfügbare Sprachen
T H E i - B R A K E S Y S T E M
SRAM's i-BRAKE is an innovative
well sealed brake system, which
combines exellent performance
with low maintenance.
Please take particular note
that the total weight of the
bicycle with cyclist and baggage
may not exceed 125 kilograms.
» The i-BRAKE is not useable for
tandems, transport bicycles, and
similar loads.
» Only 24"/26"/28" wheels are
suitable for use.
» The i-BRAKE must be mounted on
the left side of the bicycle
(viewed from the rear end).
» There is a risk of accident if
unsuitable forks or frames are
used.
» Installation of parts and acces-
sories not originally intended
could result in less than optimal
performance and/or injury.
» Regarding methods of disassem-
bly or maintenance, please con-
tact your qualified local dealer.
4
H A N D B R A K E L E V E R
» Use only Linear Pull compatible
hand brake levers.
» Leverage must be 1.9 – 2.3.
» Cable pull of at least 25 mm.
» Hand brake lever with adjustable
leverage:
Adjust the leverage to get above
described values of leverage and
cable pull. (SRAM 9.0 / 7.0 – adjust
to smallest leverage, that means
max. cable pull.)
There is a risk of accident if
unsuitable hand brake levers
are used.
B R A K E C A B L E S
Only a bike dealer should
change the brake cable.
» When choosing cable housing
lengths, be sure to allow enough
housing for an extreme turn of the
handlebars in both directions.
» Note also that different stem
lengths effect cable housing
length.
i-BRAKE · April 2004
Werbung
