Field-Bus Systems For Timetwin Digital; Standard Fieldbus Systems - Fronius Timetwin Digital Bedienungsanleitung

Field-bus sys- It is possible to interface TimeTwin Digital with the robot control using any of the
tems for TimeT-
following Twin field-bus systems:
win Digital -
-
-
-
Roboter-
Steuerung
"Twin field-bus system", installed in the power
source
Standard fiel- It is also possible to use the following standard field-bus systems to interface the
dbus systems TimeTwin Digital with the robot control:
-
-
-
-
-
Roboter-
Steuerung
"Standard field-bus system", installed in the
power source
88
Twin DeviceNet field-bus robot interface
Twin CanOpen field-bus robot interface
Twin Interbus CU field-bus robot interface
Twin Profibus field-bus robot interface
LocalNet
Feldbus
„Twin-Feldbus-
system"
Stromquelle „1"
LHSB
DeviceNet field-bus robot interface
CanOpen field-bus robot interface
Interbus CU field-bus robot interface
Interbus OWG field-bus robot interface
Profibus 1.5 MB field-bus robot interface
Roboter-
Steuerung
Feldbus
Feldbus
„Standard-
Feldbus-
system 1"
Stromquelle „1"
LHSB
In the same way as with the "Twin in-
terfaces", an SPC (stored-program
controller) is also integrated in
the "Twin field-bus systems". This SPC
carries out the logical gating of the si-
gnals. In this way, both power sources
are addressed simultaneously by one
signal from the robot control. For two
power sources, only one such "Twin
field-bus system" is needed. The "Twin
field-bus system" is mounted to one of
the power sources.
The connection to the other power
Stromquelle „2"
source is via LocalNet, and the connec-
tion to the robot control is via field
bus.
When standard field-bus systems are
used, logical gating of the signals must
„Standard-
be performed by the robot control. For
Feldbussystem 2"
two power sources, two identical stan-
dard field-bus systems are needed.
The two standard field-bus systems
are mounted on the power sources.
The connection between the robot
control and the power sources is via
LocalNet.
Stromquelle „2"