Synchronising The Power Sources; Enabling The Software; Mechanical Requirements For Timetwin Digital - Fronius Timetwin Digital Bedienungsanleitung

Synchronising In the "TimeTwin Digital" process, the power sources are synchronised by means
the power
of:
sources -
-
After the LHSB link has been installed, "Parameter P-C" (power control) will be
available. Parameter P-C is shown on the power source in Set-up Menu - Level 2.
Possible settings: On / oFF
For the "TimeTwin Digital" process, "Parameter P-C" must be set to "On" on both
power sources.
P-C
P-C
P-C
Enabling the In order to run the "TimeTwin Digital" process, you will need the "TimeTwin Digi-
software tal" software enablement (Article n° 4,061,110) on both power sources.
After the software has been enabled, and once the LHSB link has been set up,
Parameter t-C (twin control) will be available. Parameter t-C defines the leading
power source. This power source specifies the frequency for the Trailing power
source.
IMPORTANT! The software enablement of the power sources is monitored by the
LHSB link. If one of the power sources has not been enabled, meaning that Para-
meter t-C is not available on this power source, Parameter t-C will not be display-
ed on the other (i.e. enabled) power source either.
Possible settings: On / oFF
Contents of display / Making settings
-
-
Mechanical re-
In order to ensure that the "TimeTwin Digital" process is stable and reproducible,
quirements for the following mechanical requirements must be fulfilled:
TimeTwin Digital -
-
-
-
70
the optional LHSB link on the power sources
the LHSB connector cable
Leading
power source
On
On
oFF
No robot interface installed ... Parameter t-C is shown, and set, in "Set-up
Menu - Level 2" on the power source
Robot interface installed ... Parameter t-C is addressed by the robot control
in such a way that either the first or the second power source acts as the lea-
ding power source, depending on the direction of welding.
On the leading power source, Parameter t-C must be set to "On" via the ro-
bot control.
As a check: Parameter t-C is displayed on the power source, in Set-up Menu -
Level 2.
Precision torch manipulation for the robot and/or single-purpose automatic
machine (e.g. longitudinal travel carriage)
Exact seam preparation
Close weldment tolerances
Seam guidance systems with low deviation
Trailing power Application
source
On TimeTwin Digital
oFF Power-sharing TPS 7200 / 9000
oFF 2 single power sources