Welding Characteristics For Timetwin Digital; General Remarks; Spatter-Free Ignition (Sfi) In Timetwin Digital; Identification Of Timetwin Digital Welding Characteristics - Fronius Timetwin Digital Bedienungsanleitung

Welding characteristics for TimeTwin Digital

General remarks

In the "TimeTwin Digital" process, the power sources are retrofitted with a special
welding data bank for use with TimeTwin Digital.
In the following sections, you will find examples of these welding data banks.
Spatter-free If the "Spatter-free ignition" (SFI) option has been enabled on both power
ignition (SFI) in sources, then SFI must be deactivated on the second power source in cases whe-
TimeTwin Digital re the second wire electrode is to start up after a time-lag:
Parameter Fdc (feeder creep) = "oFF"
The respective SFI settings can be stored as part of a "job".
Identification of TimeTwin digital welding characteristics are identified as follows in the tables be-
TimeTwin digital low:
welding charac-
teristics
T) ... denotes the TimeTwin digital characteristic concerned
Welding charac-
teristics for
TS/TPS
4000/5000
(M500)
denotes a line containing TimeTwin digital welding characteristics
T) T)
T)
T) T)
T)
T) T) T)
T)
T) T)
T)
T)
T)
T)
T) T)
T)
T)
T) T)
T) T)
T)
T)
T) T)
83