Malfunction Table - Dibo Jmb-R Bedienungsanleitung

7. Malfunction table

At a possible malfunction one can consult the table mentioned below and if you obtain on this basis no solution, we
advise to contact a DiBO technician and/or a recognized DiBO representative.
Machine does not start
No water pressure
Instable and to weak pressure
HP pump pulse
JMB-R : REV 0
Malfunction
Battery tension too low
Key switch "OFF"
Start engine does not work
Too few oil in engine casing
Rest malfunctions
To few water inlet
Filter stuffed-up
Air in water supply (leaks in water
supply)
Nozzle or lance stuffed-up or worn-
out.
Pressure regulator defect
Rest malfunctions
Leak or congestion in supply conduit Clean/replace/repair
To much air present
Cause
Loads battery
Key switch "ON"
Consult an expert
Refill oil
Consult an expert
Repair water inlet
Clean/replace filter cartridge
Put machine completely without
power! Repair leaks in supply.
Clean or replace
Consult an expert
Consult an expert
De-aeration of cleaner
Solution
DiBO b.v. 61