Dibo JMB-R Bedienungsanleitung Seite 56

5. Turn off
5.1. Cool down the engine
Before switching off the engine, one has to run the engine always at idle and on low revolutions, to cool down
the engine.
5.2. Lance and pistol
Uncouple the lance and put it away. Close the water supply.
Roll up the high and low pressure hoses and check on damages.
5.3. Machine
Put the operating switch on OFF. Drain off the water from the supply tank (drain off tap is situated under the
trailer). loosen the pressure of the conduits by serving the spray pistol. Pay attention to cleaners with burners or
combustion engines, these parts could be hot for a while! If necessary, clean the water filter.
Slightly clean the machine with a tissue. Close the protection cover and bolt the locks.
Hold the manual and the ignition keys within arm's reach.
5.4. Water outlet
Clean to own need the water supply.
5.5. Put away machine
Store the machine in a dry and frost-free place at a horizontal and stable subsoil.
Pull the trailer brake. Turn the nose wheel downwards and bolt it.
Untie the safety cable as well as the electricity wire from the trailer. Uncouple the JMB from the pole.
5.6. Environmentally safe disposal of used fluids
No fluids (anti-scale product, oil, petrol, diesel, softener, ...) may be disposed randomly because of the environ-
ment! So make sure, if you are user, that the applicable local guidelines for environmentally friendly disposal of
these fluids (without soil pollution) are complied.
JMB-R : REV 0 DiBO b.v. 56