Maintenance Diagram - Dibo Jmb-R Bedienungsanleitung

6. Service
6.1. General
All maintenance activities must happen at an disconnected machine and hoses without pressure.
Checking the electric components can happen exclusively by an expert.
Exclusively accessories and replacement components which have been approved by the manufacturer can be
used. Directly after the activities all securities- and protection parts must be assembled, before the machine is
put in functioning."a golden rule" that contributes to a perfectly working machine with few problems, is following:
A DAILY CONTROL AND CLEANING OF THE MACHINE FREQUENTLY DO WONDERS!
To be able to guarantee a perfectly working system, one has first necessary a reliable and technical well consid-
ered machine, which is then faced secondly at regular times with a thorough maintenance.
Therefore the experience and the "know-how" of DiBO a technical good working machine is insured and large
maintenance turns can be carried out by experienced DiBO technicians by means of appointment or mainte-
nance contract, we can suppose in advance that it is satisfied to these two points.

6.2. Maintenance diagram

6.2.1 General
Check daily by means of the maintenance diagram the high pressure cleaner.
You find the maintenance diagram on the following pages.
Check even all transmission belts on good tension and possible defects.
If this case is not, then best consult the proper maintenance technicians.
PAY ATTENTION: Take care that the transmission belts aren't in movement and observe the applying safe
standards!
6.2.2. Periodic maintenance
- Control of the electric cables, high and low pres-
sure hoses and couplings and control of oil level.
- Replacement and cleaning oil filters and fuel
- All following refreshments of pump oil and reduc-
- Extra control/replacement of joints, valves, o- rings
6.2.3. Control of oil level and refreshing pump oil
Check for each use of the machine the oil with the oil level glass or with the oil level bar.
Oil must stand right with the sign of the oil level glass, if the this case is not, oil tops up until the sign.
If oil looks forward to there milky, consult directly the DiBO technicians. To refresh oil, as follows work goes:
- Unbolt the drain plug below the pump.
- Unbolt the tap with the oil level bar.
- Catch all oil in a barge and remove oil like further described in the guide.
- Force up the drain plug there and top up the oil in the breach to the upper part to on the mark line.
- Force up the tap with the oil level bar there.
- Recommended oil: 1.836.042.
6.2.4. Cleaning of the water filters
Clean the water filters regular and remove possible dirt.
6.2.5. Cleaning of the oil- and fuel filters
The oil- and fuel filters defuse and cleaning, possibly replace. Empty the fuel tank.
Remove the drain plug and catch possible dirt in a can.
Rinse clean the tank with a little it off clean fuel and turn close the drain plug.
JMB-R : REV 0
- Refreshing pump oil.
- Cleaning water filter.
filters.
- Cleaning fuel tank.
tion gearbox oil.
- Maintenance engine.
by acknowledged DiBO- technicians!
After each use.
First 50 hours.
Each 50 hours.
First 50 hours, each following 200 hours.
First 50 hours, each following 200 hours.
Each 200 hours.
See enclosed motor instruction manual.
Each 600 hours.
DiBO b.v. 58