Quick MILL 0987L Rapida Gebrauchsanweisung Seite 9

Mod. 0987L Rapida
INTRODUCTION
Keep this instruction manual in a safe place. For
any information or difficulties not fully
explained, please contact the service personnel.
1. SYMBOLS
The
identifies all the explanations of an important
nature for the safety of persons.
Follow these instructions to avoid accidents!
The numerical symbol, numbers or letters
2
refer to illustrations and parts of the
machine such as buttons, lights, etc.
The manufacturer
responsibility for any damages in the
event of:

Uses not in accordance with the
intended purposes;

Alterations made to the power cable;

Alterations made to any component
part of the machine;

Use of non-original components or
accessories;

Repairs not
authorised service centre;
This product meets the labelling
requirements
Directive (2002/96/CE). The symbol
indicates that
electronic product must not be discarded with
normal household waste. PRODUCT CATEGORY
with references to the type of equipment listed
in Annex 1 of the RAEE Directive. This product is
in category 2, "Small domestic appliances".
DO NOT DISCARD WITH NORMAL HOUSEHOLD
WASTE
The failure to observe the above mentioned
points voids the guarantee.
2. WARNINGS
The packaging material (plastic bags, polystyrene,
nails, cardboard, etc.) must not be left within the
reach of children as they are a potential sources of
danger.
The machine in its packaging is to be stored in a dry
location, free from humidity and protected from the
elements. The temperature must not be lower than
+5 °C.
warning triangle
assumes no
carried out by an
set out in RAEE
this electrical or
A maximum of three packages containing pieces of the
same type may be stacked, one on top of the other. Do
not stack heavy packages on boxes of a different type.
Before connecting the machine to the power supply,
make certain that the rating plate corresponds to the
requirements of the electrical grid.
The power cable must lie flat (avoid curling or
overlapping) in a position which is not exposed to
any impacts or handling by minors. It must not be
placed near liquids, water or heat sources, and must
not be damaged (if necessary have qualified
personnel replace it).
The use of adapters, multiple sockets and/or
extensions is not advised. Whenever their use is
absolutely necessary, only use products with quality
certification markings (IMQ, VDE, +S, etc.), and
ensure that the power rating stamp is higher than
the absorption (A = amps) of the equipment to be
attached.
 In the event of doubt or uncertainty, have qualified
personnel check the electrical power supply which
must correspond to the provisions required by the
current safety regulations, including:
- proper earthing;
- conductor section is suitable for the absorption
capacity;
- efficient residual current device.
 Position the machine on a hydro-repellent surface
(laminated, stainless steel, ceramic, etc.) away from
heat sources (ovens, stove tops, fireplaces, etc.) and
in an environment where the temperature does not
drop below 5 °C.
Do not expose the machine to the elements, or install
it in an environment with high humidity, such as a
bathroom area.
If the need for a replacement part arises, contact a
distributor or Authorised Retailer and only used
original spare parts.
In the event of damage to objects or persons
caused by the improper installation or use,
the manufacturer cannot be considered
responsible.
3 - DESCRIPTION OF THE MACHINE
Description of the controls
1. Main switch
2. Group lever
3. Hot water delivery
4. Coffee delivery group
5. Filter holder
6. Steam spout
7. Steam tap
8. Hot water tap
Rev. 00
8
8