Putting Out Of Operation - Quick MILL 0995 2B Gebrauchsanleitung

Mod. 0995P LED
10.3 Special maintenance
The machine comes with a blind filter for cleaning the
unit. This operation must be done at least once a week to
remove coffee encrustations from the circuit.
9. Unhook the filter holder from the unit.
10. Remove the filter from the filter holder and insert
the blind filter.
11. Hook the filter holder to the unit.
12. Start dispensing coffee for around 15 seconds and
then stop dispensing. Repeat the operation 10-15
times.
10.4 Descaling
1. Put the descaling product in the water tank
(following the instruction of the supplier)
2. raise the coffee lever and open the water wand till the
water tank is empty
Close the water knob and pull down the coffee lever
again.
3. Full and rinse the water tank with clean water
4. Let act the descaling product for ca. an hour
Rinse
5. Raise the coffee lever again and open the water knob
till the water tank is empty
6. Now switch the machine off and let the coffee lever
up and the water knob open.
7. Once the machine is completely cold, open the taps
and drain the water of the boilers (pic. 3, pos. 21)
8. Once the boilers are empty, close the drain taps and
reassemble the lock plate again.

11. PUTTING OUT OF OPERATION

11.1. Temporary
 Empty the water tank (Fig. 2, pos. 18) and the drip
tray.
 Turn off all switches and unplug the power-supply
plug.
 Perform the maintenance operations
 Store the machine in a dry place, protected from
inclement weather and where only qualified people
have access (do not leave it within the reach of minors
or incapacitated adults).
11.2. Definitive
Besides the temporary putting out of operation
procedures, do the following:
 Cut the power cord,
 Pack the machine in a carton or other and deliver it to
the personnel in charge (authorised waste disposal or
used appliance pick up).
12. POSSIBLE PROBLEMS
If the power cord is damaged, contact an authorised
service centre to have it replaced since it requires the use
of a special tool.
Waste materials used for processing or maintenance, if
they are not biodegradable or are polluting, should be
put in separate containers and delivered to the
appropriate collection centres.
Checks that can be carried out by the user after having
disconnected the electric power supply.
A) The machine does not turn on:
- Make sure that it is plugged in;
- Make sure that the mains current is present and that the
cut-out or main switch is connected;
- Check the condition of the plug and of the power cord;
have them replaced by qualified personnel if they are
damaged.
B) The machine does not dispense coffee:
- No water in the tank; restore the water level.
C) The machine does not dispense hot water or
steam:
- No water in the tank; restore the water level.
- Hot water nozzle clogged; disassemble and clean.
- Nozzles clogged; clean the steam wand nozzles with a
pin.
E) Irregular coffee dispensing:
- Clean the filter found in the filter holder.
- Coffee grinding too fine or too coarse.
For all other types of unspecified defect or problem,
unplug the power-supply plug, do not carry out
repairs or checks on your own and contact a
qualified technical service centre.
Rev. 00
13 13