Instant Pot PRO CRISP Bedienungsanleitung Seite 32

Care, cleaning and storage
Removing and installing parts
Silicone sealing ring
Remove the sealing ring
Grip the edge of the silicone and pull the
sealing ring out from behind the circular
stainless steel sealing ring rack.
With the sealing ring removed, check
the ring rack to make sure it is secured,
centred and an even height all the way
around the lid. Do not attempt to repair
a distorted ring rack.
Instant Tip: The sealing ring is easier
to remove and install when it's wet
and soapy.
Install the sealing ring
Place the sealing ring over the sealing ring
rack and firmly press it into place. Make
sure there's no puckering.
It should be snug behind the sealing
ring rack. It may wiggle a bit but
shouldn't fall out when you turn
the lid over.
32 | support@instantpot.co.uk | +44 (0) 3331 230051
Pro-Crisp-UK-ENG-GSG-2021-03-23.indd 32 Pro-Crisp-UK-ENG-GSG-2021-03-23.indd 32
Steam release assembly
Remove the steam release assembly
Remove the steam release cover, then
pull the steam release valve up and off
the steam release pipe.
Install the steam release assembly
Place the steam release valve on the steam
release pipe and press down firmly.
The steam release valve sits loosely
on the steam release pipe but should
remain in place when the lid is
turned over.
Place the steam release cover over the
steam release valve and press down.
The cover pressure-fits in place.
QuickCool protective cover
Remove the protective cover
Grip the tab and push it towards the lid
handle, then pull it up, towards you, and off.
Install the protective cover
Grip the tab and slide the cover towards the
lid handle, then press down until it clicks.
3/23/21 1:42 PM 3/23/21 1:42 PM