Instant Pot PRO CRISP Bedienungsanleitung Seite 33

Care, cleaning and storage
Anti-block shield
Remove the anti-block shield
Grip the lid like a steering wheel and use
your thumbs to press firmly against the
side of the anti-block shield (pressing
towards the side of the lid and up) until it
pops off the prongs underneath.
Install the anti-block shield
Place the anti-block shield over the prongs
and press down until it snaps into position.
Float valve and silicone cap
Remove the float valve from the lid
Place one finger on the flat top of the float
valve, then turn the lid over. Detach the
silicone cap from the bottom side of the
float valve, and remove the float valve from
the top of the lid.
Top
Pro-Crisp-UK-ENG-GSG-2021-03-23.indd 33 Pro-Crisp-UK-ENG-GSG-2021-03-23.indd 33
Bottom
Do not discard the float valve or
silicone cap!
Install the float valve
Drop the narrow end of the float valve into
the float valve hole on the top of the lid.
Place one finger on the flat top of the float
valve, then turn the lid over. Firmly attach
the silicone cap to the bottom of the float
valve.
Condensation collector
The condensation collector sits at the back
of the multicooker base and catches any
overflow from the condensation rim.
Remove the condensation collector
Pull the condensation collector away from
the multicooker base; do not pull down.
Note the tabs on the multicooker base
and the grooves on the condensation
collector.
Install the condensation collector
Align the grooves on the condensation
collector over the tabs on the back
of the multicooker base and slide the
condensation collector into place like
closing a drawer.
Instantpot.co.uk | 33
3/23/21 1:42 PM 3/23/21 1:42 PM