Abicor Binzel EWR 2 Net MFC-Mode Originalbetriebsanleitung Seite 57

EWR 2 Net MFC Mode
Tab. 12 Commands/parameters – serial and Ethernet
Command r/w Authorization Reply
fmax x
r/w r-all
w-Setter
foffs x r/w r-all
w-Setter
outp x r/w r-all
w-Setter
copid x r/w r-all
w-Setter
copbd x r/w r-all
w-Setter
Ip w x y z r/w
r-all
w-Setter
nmask w r/w r-all
x y z w-Setter
Gateway
r/w r-all
w x y z
w-Setter
dhcpip x r/w r-all
w-Setter
tcpto x r/w r-all
w-Setter
mfcto x r/w r-all
w-Setter
mfcfb x r/w r-all
w-Setter
mfcsp x r/w r-all
w-Setter
Error messages
Description
fmax x Basic flow
x = basic flow in I/min
foffs x Flow offset at maximum x = offset flow in Nl/min
outp x Outlet stagnation pressure
x = pressure in 1/10 bar
copid x CANopen Node ID
x = CANopen Node ID
x = 0 ≙ 125 kBit/s
copbd x CANopen baud rate (speed)
x = 1 ≙ 250 kBit/s
x = 2 ≙ 500 kBit/s
x = 3 ≙ 1000 kBit/s
Ip w x y z IP address for TCP server.
A restart is required to adopt the IP.
nmask w x y z Netmask for TCP server.
A restart is required to adopt the IP.
Gateway Gateway for TCP server
w x y z
A restart is required to adopt the IP.
dhcpip x Change-over switch DHCP/static IP.
x = 1 DHCP
x = 0 static IP
tcpto x Set the TCP timeout; if there is no communication for this
time, the TCP connection is disconnected. Establishing
connection again is required.
x = 0 off, no timeout
x = 1 to 10,000 timeout in ms
mfcto x Setting the timeout. If no new value has been received via
mfcsp for this time, the device control uses the value set
via mfcfb (fallback value).
0 = function deactivated, the device control uses the last
setpoint value received and the fallback value is ignored.
mfcfb x Value to which the device resets its control after the set
timeout.
mfcsp x Set point for the control.
err 1 Unknown command
err 2 Number of arguments incorrect/authorization does
not exist.
err 3 Value range of arguments infringement.
13 Description of interface
Value range
x = 2 to 23
x = 0 to 7
x = 2 to 20
x = 0 to 255
x = 0 to 3
w = 0 to 255
x = 0 to 255
y = 0 to 255
z = 0 to 255
w = 0 to 255
x = 0 to 255
y = 0 to 255
z = 0 to 255
w = 0 to 255
x = 0 to 255
y = 0 to 255
z = 0 to 255
x = 0 or 1
x = 0 to 10,000
x = 0 or
1 to 10,000 ms
x = 0 or
2 to 30 l/min
x = 0 or
2 to 30 l/min
EN - 25