Abicor Binzel EWR 2 Net MFC-Mode Originalbetriebsanleitung Seite 37

EWR 2 Net MFC Mode
1.4 Classification of the warnings
The warnings used in the operating instructions are divided into four different levels and shown prior to
potentially dangerous work steps. Depending on the type of danger, the following signal words will be used:
Describes an imminent threatening danger. If not avoided, it may cause severe injuries or death.
Describes a potentially dangerous situation. If not avoided, this may result in death or serious injuries.
Describes a potentially harmful situation. If not avoided, this may result in slight or minor injuries.
NOTICE
Describes the risk of impairing work results, material damage, or irreparable damage to the device or
equipment.
2 Safety
This chapter describes the essential safety requirements and warns of residual hazards that should be kept
in mind to operate the product safely. Non-observance of the safety instructions may result in risks to the life
and health of personnel as well as cause environmental or material damage.
2.1 Designated use
The device described in these operating instructions may be used only for the purpose and in the manner
described in these operating instructions. The device is used to regulate the gas supply during MIG/MAG
and TIG gas welding. Any other use is considered improper. Unauthorized modifications or changes to
enhance the performance are not permitted.
► Do not exceed the maximum load data specified in the documentation. Excessive loads lead to
irreparable damage.
► Do not make any constructive changes to this device.
► Do not use or store the device outdoors where it is wet.
2.2 Responsibilities of the user
► Ensure that only suitably qualified personnel perform work on the device or system.
Suitably qualified personnel are:
— those who are familiar with the basic regulations on occupational safety and accident prevention;
— those who have been instructed on how to handle the device;
— those who have read and understood these operating instructions;
— those who have been trained accordingly;
— those who are able to recognize possible risks because of their special training, knowledge, and
► Keep non-suitably qualified people out of the work area.
2.3 Warning and notice signs
The following warning, notice and mandatory signs can be found on the product:
These markings must always be legible. They may not be covered, obscured, painted over, or removed.
DANGER
WARNING
CAUTION
experience.
► During initial installation or after service, note the date the next service is due on the
device's label using a water- and wipe-resistant industrial marker (date of
commissioning or service plus one year).
Noting the date is for self-monitoring purposes. Regular service is necessary to fulfill the
warranty conditions.
 10 Maintenance and cleaning on page EN-20
2 Safety
EN - 5