Abicor Binzel EWR 2 Net MFC-Mode Originalbetriebsanleitung Seite 53

EWR 2 Net MFC Mode
Tab. 11
Fault
Close the gas supply.
1
Disconnect the power supply.
2
Switch off the entire welding system.
3
Remove the connecting cable from the power supply.
4
Remove the shunt and connecting cable.
5
Remove the Ethernet cable.
6
Remove the insulating gas hose from the gas supply line and the gas discharge line.
7
12 Disposal
12.1 Disposal of materials
This product is mainly made of metallic materials that can be melted in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are labeled in preparation for their sorting and
separation for later recycling.
12.2 Disposal of consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These
substances must be stored, transported and disposed of in suitable containers. Contaminated cleaning tools
(brushes, rags, etc.) must also be disposed of in accordance with the information provided by the
consumables' manufacturer.
► Please observe the relevant local regulations and disposal instructions in the safety data sheets
specified by the manufacturer of the consumables.
Faults and troubleshooting
Cause
Internal error is present.
Internal error is present.
Temperature is not in the required
range.
The gas volume flow cannot be
achieved when the valve is completely
open due to back pressure that is
too high.
The gas volume flow cannot be
achieved when the valve is completely
open due to input pressure that is
too low.
Equipment marked with this symbol is covered by European Directive 2012/19/EU on
waste electrical and electronic equipment (WEEE).
► Do not dispose of electrical devices with household waste.
► Disassemble electrical devices prior to their proper disposal.
 on page EN-20
► Collect electrical equipment components separately and recycle in an
environmentally responsible manner.
► Observe local regulations, laws, provisions, standards, and directives.
► Please consult your local authority for information about collection and return of
electrical devices.
12 Disposal
Troubleshooting
► Contact ABICOR BINZEL Service
to have the device recalibrated by
ABICOR BINZEL service personnel.
► Disconnect the device from the
power supply, allow it to cool down
and contact ABICOR BINZEL
Service.
► Check all system lines (is a line
bent?).
► Check the status of the welding
torch's gas nozzle and replace,
if necessary.
► Maintain the required input
pressure.
 4.4 Technical data on
page EN-11
EN - 21