Abicor Binzel EWR 2 Net MFC-Mode Originalbetriebsanleitung Seite 43

EWR 2 Net MFC Mode
4.3.5 Ethernet connection (G)
(M12 socket, 4-pole, D-coded)
The Ethernet interface is used to enter the set point value of the gas flow, to record the process data, and to
configure the device.
NOTICE
Damage to the device due to faulty connection
If the wrong cable is connected to the Ethernet connection the device can become damaged.
► Connect only a network cable to the Ethernet connection.
► Do not connect any voltage (Power over Ethernet/PoE) to the device.
Tab. 7
4.4 Technical data
Tab. 8
Ambient temperature
Media temperature
Relative humidity
Tab. 9
Basic flow
Set pressure
Gas type
Tab. 10
Material
Weight
Dimensions (L × W × H)
Fitting position
Fluidic connectors
Recording of gas consumption
Calibration at operation site
Communication via jack
CANopen interface
(e.g., for communication with other
systems)
Ethernet interface
(e.g., for quality assurance/communication
with other systems)
Active regulation of the gas volume flow
Protection type
Operating voltage
Max. power consumption
Pressure range (relative pressure)
Flow pressure during operation
(gas inlet pressure range)
Pressure flow range
Pin assignment for Ethernet connection
PIN
1
2
3
4
Ambient conditions, transport, storage and operation
Factory basic settings
General information
4 Product description
Name
Tx+ (Send)
Rx+ (Receive)
Tx− (Send)
Rx− (Receive)
−10 °C – +50 °C
+10 °C – +40 °C
20%–90%
14 l/min
0.6 bar
92/8
EWR 2 Net MFC Mode
Housing: aluminum, black lacquer
Approx. 670 g
178.5 mm × 51 mm × 83 mm
Wall mounting, connectors at the bottom
Hose connectors, 6 mm
ABICOR BINZEL service software
x
x
–
–
x
IP54
24 V DC ± 20%
20 W
p = 1–6 bar / p = max. 2 bar
IN OUT
min. 1 bar–max. 6 bar
Q = 2 to 30 ± 1 l/min
air
EN - 11