G&D VisionXS-F-DP-UHR Installation Und Bedienung Seite 189

Changing the scancode set of PS/2 keyboards
If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the
PS/2 keyboard with the scancode set 2.
ADVICE: Use the scancode set 3 if you cannot enter the pipe "|" or the arrow keys
do not work as expected.
How to change the setting of the scancode set:
1. Press
Ctrl+Num
2. Select the row
3. Under Scancode set
2  activates scancode set 2 for PS/2 keyboard inputs
 activates scancode set 3 for PS/2 keyboard inputs
3
4. Press to save your settings.
F2
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
(default) to open the OSD.
and press
Console setup
press F8 to select one of the following options:
.
Enter
G&D VisionXS-F-DP-UHR · 77
Configuration