G&D VisionXS-F-DP-UHR Installation Und Bedienung Seite 180

Configuration
Active console after starting an extender
IMPORTANT:
The activation of the
and the connection to a second console module are prerequisites for this
transceiver
operation option.
When selecting the
modules do not show an image after restarting the extender. Only after an input is
made at one console, its image is displayed on the monitor.
The setting Active console after start
play you want to activate immediately after starting the extender.
How to select whether and on which module the image display is activated after
restarting the extender:
1. Press Ctrl+Num
2. Select the row
3. Under Active at startup
 After restarting the extender, the image display of buth modules
none
remote 1  After restarting the extender, the image display of the console
remote 2  After restarting the extender, the image display of the console
4. Press F2 to save your settings.
Related topics:
 Changing the time span of the input lock on page 64
 Right for exclusive access to the console on page 65
68 · G&D VisionXS-F-DP-UHR
Transm. Redundancy
Image display option
allows you to define a module whose image dis-
(default) to open the OSD.
and press
System setup
select one of the following options:
is switched off (default)
connected to Transmission 1 is activated
connected to Transmission 2 is activated
feature, an additional
keep off / Permanently off
.
Enter
SFP
(see page 66 f.) both