G&D VisionXS-F-DP-UHR Installation Und Bedienung Seite 169

Changing your password
IMPORTANT: The OpenAccess operating mode is set by default. In this operating
mode, access to the KVM extender is not protected by authentication. Information
on the operating modes can be found in chapter Changing hotkeys on page 58 ff.
How to change the password of you user account:
1. Press Ctrl+Num
2. Press F10 to open the
3. Select the Change password entry and press
4. Enter the new password into the Change own password menu:
New  Enter your new password.
Repeat  Repeat your new password.
5. Press to save your settings.
F2
Selecting the language
The specified system language is assigned to all user accounts by default. If required,
you can permanently assign a (different) language to each user account.
NOTE: All language settings apply to both the web application and the OSD of the
device.
If the OSD does not support the selected language, the OSD will be displayed in
English.
How to set the language:
1. Press Ctrl+Num
2. Press F10 to open the
3. Under Language
Use the system language
from system
[Selection]  Use the selected language
4. Press F2 to save your settings.
(default) to open the OSD.
Personal Profile menu.
(default) to open the OSD.
Personal Profile menu.
press F8 to choose between the following options:
Configuration
.
Enter
G&D VisionXS-F-DP-UHR · 57