Configuration settings
Operating modes of console modules
Depending on the application of the KVM extender, you can select one of the fol-
lowing operating modes:
OpenAccess mode:
In this mode, access to the KVM extender is not protected by
authentication.
NOTE:
This operating mode is set by default.
You can configure the same access rights for both a KVM extender and a user
account.
IMPORTANT:
The configured access rights apply to all users working with this
KVM extender.
Standard mode:
The default mode allows access to the KVM extender only after
users are authenticated with their username, password, and 2-factor authentication
if set up.
NOTE:
This operating mode is set by default, if you use the extender as a
(see Optional connection to a KVM matrix switch on page 5).
switch module
User rights can be configured in the individual user account.
How to select the operating mode of the KVM extender:
1. Press
Ctrl+Num
2. Select the row
3. Under
Console type
OpenAccess
OpenAccess mode (default)
Standard mode
Standard
4. Press
to save your settings.
F2
(default) to open the OSD.
Console setup
and press
, select one of the following options:
Enter
.
G&D VisionXS-F-DP-UHR · 55
Configuration
matrix