G&D VisionXS-F-DP-UHR Installation Und Bedienung Seite 148

Web application Config Panel
Web application Config Panel
The web application provides a graphical user interface to configure and
Config Panel
monitor the KVM extender.
Basic operation of the web application
The web application can be used in the entire network independently from the loca-
tions of the devices and consoles connected to the KVM system.
NOTE:
The separate manual provides information about system requirements, the
required configuration of the network interfaces at the
and the operation of the web application.
Starting the web application
Config Panel
How to start the
1. Enter the following URL in the address bar:
https://[IP address of the user or computer module]
2. Enter the following data in the login mask:
Username:
Password:
IMPORTANT:
Change the administrator account's default password.
The default access data is:
 Username:
 Password:
3. Click on .
Login
Selecting the language of the web application
NOTE: The selected language is saved in the user settings of the active user. The
next time this user logs on, the previously selected language setting is applied.
How to change the language of the web application:
1. Click the language identifier of the current language in the upper right
corner.
2. Switch the language to be used by clicking on the desired language.
36 · G&D VisionXS-F-DP-UHR
web application:
Enter a username.
Enter a password for your user account.
Admin
see login information on the label on the bottom of the device
VisionXS-F-DP-UHR
devices